Attack is a high powered pre-conditioner which combines active enzymes, surfactants, softeners and grease lifters that will thoroughly clean a broad spectrum of fibres. Attack effectively removes animal, vegetable and petroleum oils, cooking and food residues, leaving traffic areas and heavily soiled carpet completely clean.
- Active enzymes digest food soils and greases
- Excellent for use on restaurant carpets
- Dissolves easily in warm to hot water
- Effectively removes most urine spots
- Diluted pH: 11
- Dilution Ratio: 1:128
- 8lb jug (4/case)
DIRECTIONS FOR USE:
Pretest in an inconspicuous location for color fastness and fibre stability.
Pump-up or Power Sprayer: For Light Soil Conditions: Mix 1 - 2 oz of Attack into 1 gal (3.78 L) of warm to hot water. Mix until completely dissolved (up to 1:128 Dilution).
For Heavy Soil Conditions: Mix 2 - 3 oz of Attack into 1 gal (3.78 L) of warm to hot water. Mix until completely dissolved (up to 1:64 Dilution).
Hydro-Force™ Sprayer: 4:1 Dilution (No Tip): Mix 10 oz of Attack into Hydro-Force™ jug and fill with hot water. Shake until completely dissolved.
8:1 Dilution (Yellow Tip): Mix 18 oz of Attack into Hydro-Force™ jug and fill with hot water. Shake until completely dissolved.
For best results: Pile lift or vacuum carpet prior to cleaning. Spray diluted Attack pre-conditioner onto carpet at the rate of 800-1000 square feet per gallon (3.78 L). Agitate presprayed area using a carpet groomer. Allow 15 minutes dwell time, then rinse with Esteam Fibre Rinse solution in conjunction with hot water extraction.
Caution: Product not recommended for use on wool or natural fibres.
NOTE: Do not mix Esteam Attack with any other chemical product.
No posts found