Esteam Tile & Grout Sealer, gal

Add to Cart to See Price
C101-935

Tile & Grout Sealer is a water based, ready to use, penetrating sealer that forms a durable transparent barrier against oil and water based soils. Tile & Grout Sealer chemically bonds to all grout lines and porous unglazed tile such as marble, granite, limestone, slate, terrazzo, sandstone and flag stone.

  • Penetrating sealer
  • Low VOC
  • Transparent barrier
  • Durable protection
  • Chemically bonds to surface
  • Allows surface to breath
  • Dilution ratio: RTU
  • pH: 4.3
  • Gallon (4/case)

DIRECTIONS FOR USE:

Pretest in an inconspicuous area for compatibility.

Prepare surface by cleaning with Esteam Tile & Grout Neutral Cleaner, rinse floor thoroughly with clean water, remove excess water, allow to dry.

This product is ready to use, do not dilute: For best results Tile & Grout Sealer should be applied to clean dry floors.

Avoid over spray onto surrounding surfaces. Evenly appy a liberal amount of sealer by using a pump up sprayer, mop or roller for full
coverage. If only sealing grout, a small brush can be used. Wipe off or squeegee any excess from non porous tile surfaces. Allow sealer
to penetrate for 15 to 20 minutes then wipe up extra sealer. A second coat may be applied for those extra porous and absorbent
surfaces after 30 minutes.

One gallon of Tile & Grout Sealer protects approximately 400 to 800 square feet of surface. Coverage will vary depending on porosity
and absorbency of the tile and grout. Sealer cures in 24 hours, foot traffic can resume after 8 hours

Manufacturer:
Esteam
pH:
4.3

Spec Sheet (TileSealer_spec.pdf, 347 Kb) [Download]

SDS (TILE-GROUT-SEALER-sds.pdf, 94 Kb) [Download]

No posts found

Write a review