Injectidry HP60 PLUS Wall & Ceiling Package, HP-PLUS-01

CODE: HP-PLUS-01

This HP-PLUS Package is designed specifically for drying walls & ceilings using our patented Active Hoseline dries up to 100 linear feet as packaged. Several decibels quieter than even the quiet HP60, no breaker tripping on startup, consistent pressure with no need for pressure relief valves. Dries water damaged walls and ceilings by injecting air between stud cavities using 1/16 inch (wall) 1/4 inch (cabinet) holes (or removing moist air with negative pressure).

Comes complete with patented Active Hoseline, Tubing, Injectors, Manifolds, Hosecuffs & Carry Bags. Open the product sheet to see specs and package detail with job photos. Purchase accessories to increase your system’s capabilities by purchasing Vac-It Panels (patent pending). When drying in negative mode it is necessary to use our Water Separator to protect your blower.

Features

• Quieter: No hissing noise from pressure relief valves
• Easier to set up. No questions in the minds of the technician about the pressure relief valves
• Less cumbersome
• No breaker tripping unless the breaker is faulty or you have too much equipment on the circuit. Amperage will never exceed 12 amps
• Going to move more air under all setup conditions
• Going to adjust to maximum vacuum suction whether you are using 1 panel or 20
• Usable with all attachments and hoses you now have
• CUL & ETL Listed

Specifications

• Total System Airflow: 120 CFM (cubic feet per minute)
• Static Pressure (Maximum): 60” (water lift) and still has 55 CFM
• Motor Type: Industrial Regenerative Blower, 3 Phase runs on Single phase 15A household circuit.
• Power Draw: 115v 15A circuit - does not exceed 12 amps
• Drying Modes:  Negatively or Positively

What are in the boxes?